Help

Pops and clicks


The performance of the plugins depends on the speed of your hard drive, your CPU the drivers of your audio interface and the performance of other plugins you’re using in the project.

If you’re getting pops and clicks when playing the instrument, here are a few things to try:

Note:
Make sure you’re using the latest version of the plugin before proceeding.


 Set the sample streaming mode to match your drive:
1. Click on the FELT INSTRUMENTS text located on the top right corner of the plugin’s interface.
2. Select the type of drive that the samples are stored on.

These settings will be saved so every new instance of the plugin will load with the optimizations already in place.

Move the samples to a faster hard drive:
If you have a few hard drives in your system, it’s best to keep the samples on the fastest available.

Check your buffer settings:
Open your DAW’s preferences and select a buffer that would be less taxing on your CPU and audio drivers. 128 is a nice place to start but you might want to experiment with this setting to see how it affects the performance on your system.

Run the session at 48kHz:
All Felt Instruments’ plugins use a 48kHz sample pool. If you’re running your session at a different sample rate, the plugin will convert the sample rate in real time. If none of the above solutions helped to solve your issue, you could get a better performance by setting the sample rate to 48kHz in your DAW.

Close the web browser.
Seriously.

Freeze unused tracks and effects:
Some plugins, especially those that are sample-based may put a lot of strain on your hard drive. Freezing some of these tracks may improve the performance of your session. Please, consult your DAW’s manual on how to freeze tracks.